How to use PICkit 2 clone ?
step 1: PICkit 2 clone, there are two connectors inbuilt in the device.
step 2: Connect Micro USB connector in one end of PICkit 2 .
step 3: Other end of Micro USB connector from PICkit 2 is connect to pc/laptop.
step 4: Light the Green LED ( power LED) on the PICkit 2. Now PICkit 2 is ready.
step 5: Connect RMC male connector in other end of the PICkit 2.
step 6: Other end of RMC connector from PICkit 2 is connect to PIC through ICSP ( In Circuit Serial programming ).
step 7: Check the power on target board